华西口腔医学杂志 ›› 2019, Vol. 37 ›› Issue (1): 42-47.doi: 10.7518/hxkq.2019.01.008

• 基础研究 • 上一篇    下一篇

三壁骨缺损对牙周膜应力影响的三维有限元分析

王爽1,孙江1(),于雁云2   

  1. 1. 大连市口腔医院牙周科,大连 116021
    2. 大连理工大学运载工程与力学学部,大连 116023
  • 收稿日期:2018-02-28 修回日期:2018-11-09 出版日期:2019-02-01 发布日期:2019-02-01
  • 通讯作者: 孙江 E-mail:sunjiangdl@sohu.com
  • 作者简介:王爽,主治医师,硕士,E-mail:wangshuang.oral@163.com

Influence of three-wall osseous defects on periodontal ligament stress with three-dimensional finite element analysis

Shuang Wang1,Jiang Sun1(),Yanyun Yu2   

  1. 1. Dept. of Periodontics, Dalian Stomatological Hospital, Dalian 116021, China
    2. Faculty of Vehicle Engineering and Mechanics, Dalian University of Technology, Dalian 116023, China
  • Received:2018-02-28 Revised:2018-11-09 Online:2019-02-01 Published:2019-02-01
  • Contact: Jiang Sun E-mail:sunjiangdl@sohu.com

摘要:

目的 研究三壁骨缺损对正常咬合力下牙周膜应力的影响。方法 基于锥形束CT(CBCT)的DICOM格式数据,分别建立下颌全牙列牙齿、牙周膜和牙槽骨的有限元模型。采用修改骨缺损区域单元弹性模量的方法分别模拟位于近中和远中的不同深度(占根长1/3、2/3和3/3)的邻面三壁骨缺损。对骨缺损的牙齿施加与牙体长轴呈45°的正常咬合力,分析牙周膜等效应力。结果 牙槽骨无缺损时,14颗牙齿的牙周膜等效应力平均值为5.71 MPa。牙槽骨缺损深度占根长1/3、2/3和3/3时,牙周膜等效应力平均值分别为6.61、7.14、7.42 MPa。随着三壁骨缺损深度的增加,牙周膜应力明显增大,吸收的前期应力增量大于后期。位于近中的不同深度(占根长1/3、2/3和3/3)的邻面三壁骨缺损牙周膜等效应力平均值分别为6.62、7.19、7.51 MPa,位于远中的不同深度(占根长1/3、2/3和3/3)的邻面三壁骨缺损牙周膜等效应力平均值分别为6.60、7.10、7.33 MPa。三壁骨缺损位于牙齿近中或远中,对其牙周膜的应力影响无显著差异。在相同缺损深度下,各类牙齿牙周膜等效应力大小关系为前磨牙>磨牙>切牙>尖牙。结论 即使较浅的三壁骨缺损,仍然会造成牙周膜应力的明显增加,因此对于早期的三壁骨缺损患牙,在临床上要引起充分的重视,尽早治疗干预。

关键词: 牙周膜, 应力, 牙槽骨垂直吸收, 三壁骨缺损

Abstract:

Objective This study aims to explore the influence of three-wall osseous defects on periodontal ligament stress under normal occlusal forces. Methods A finite element model for mandibular total dentition, periodontal ligament and alveolar bone was created based on cone beam computed tomography (CBCT) DICOM images. Mesial or distal proximal three-wall osseous defects at varying depths (namely, 1/3, 2/3 and 3/3 of the root) were simulated by modifying the elastic modulus of elements within the defects area. Occlusal forces with an angle of 45° to the long axis of the tooth were applied to the finite element model. In addition, the equivalent stresses of the periodontal ligament were analysed. Results In the case of no bone defect, the mean value of the periodontal ligament equivalent stress of 14 teeth was 5.71 MPa. The equivalent stresses of the periodontal ligament at different depths (namely, 1/3, 2/3 and 3/3 of the root) were 6.61, 7.14 and 7.42 MPa, respectively. With increasing depth of the osseous defects, stress on the periodontal ligament increased considerably, and the initial stress increment was greater than that of a later stage. Periodontal ligament stresses with mesial proximal three-wall osseous defects (at depths of 1/3, 2/3 and 3/3 of the root) were 6.62, 7.19 and 7.51 MPa respectively. Periodontal ligament stresses with distal proximal three-wall osseous defects (at depths of 1/3, 2/3 and 3/3 of the root) were 6.60, 7.10 and 7.33 MPa, respectively. For three-wall osseous defects located in the mesial surface and distal surface, a significant difference in periodontal ligament stress was lacking. In the case of the same absorption depth, the size relationship of periodontal liga-ment stress was in the following order: premolars>molars>incisors>canines. Conclusion Shallow three-wall osseous defects will likely cause a notable loss in strength of the periodontal ligament. Therefore, teeth with three-wall osseous defects should become the focus of clinical research. Treatment for these teeth should be administered as early as possible.

Key words: periodontal ligament, stress, vertical bone defects, three-wall osseous defects

中图分类号: