华西口腔医学杂志

• 基础研究 • 上一篇    下一篇

氟离子注入钛表面改性对成骨细胞黏着斑形成的影响

刘慧颖1, 王学金2, 伊哲1, 王浪平3, 王小峰3, 艾红军1   

  1. 1.中国医科大学口腔医院口腔修复科, 辽宁沈阳110001; 2.大连大学附属中山医院口腔科, 辽宁大连116001; 3.哈尔滨工业大学现代焊接生产技术国家重点实验室, 黑龙江哈尔滨150001
  • 收稿日期:2008-04-25 修回日期:2008-04-25 出版日期:2008-04-20 发布日期:2008-04-20
  • 通讯作者: 艾红军,Tel:024- 22891420
  • 作者简介:刘慧颖(1975-),女,吉林人,主治医师,博士
  • 基金资助:

    辽宁省教育厅基金资助项目(05L481)

Influence of fluor ide ion- implanted titanium on the formation of focal adhesion plaque in vitro

LIU Huiying1, WANG Xue- jin2, YI Zhe1, WANG Lang- ping3, WANG Xiao- feng3, AI Hong- jun1   

  1. 1. Dept. of Prosthodontics, School of Stomatology, China Medical University, Shenyang 110001, China; 2. Dept. of Stomatology, Affiliated Zhongshan Hospital of Dalian University, Dalian 116001, China;3. State Key Laboratory of Advanced Welding Production Technology, Harbin Institute of Technology, Harbin 150001, China
  • Received:2008-04-25 Revised:2008-04-25 Online:2008-04-20 Published:2008-04-20
  • Contact: AI Hong- jun,Tel:024- 22891420

摘要:

目的探讨氟离子注入纯钛进行表面改性后,钛表面改性层化学组成的变化及其对人成骨细胞样细胞系MG- 63黏着斑形成的影响。方法应用等离子体浸没离子注入装置对钛试件进行氟离子注入,通过X线光电子能谱(XPS)分析研究其表面化学组成和各元素的化学结合价态。将人MG- 63细胞接种于氟离子注入组和纯钛组钛试件表面,用激光共聚焦显微镜观察两组钛试件表面对人MG- 63细胞黏着斑形成的影响。结果XPS全谱图显示氟离子注入后试件由钛、氧、氟和碳元素组成,拟合结果显示钛表面改性层的元素以二氧化钛和三氟化钛的形式存在。MG-63细胞培养6 h后,氟离子注入组钛试件表面的黏着斑形成数量比纯钛组钛试件表面形成得多,二者间差异具有统计学意义(P<0.05)。结论氟离子注入可成功地将氟元素引入纯钛表面形成含有二氧化钛和三氟化钛的表面改性层,该层可促进成骨细胞黏附初期黏着斑的形成,提示其具有良好的生物相容性。

关键词: 钛, 等离子体浸没离子注入技术, 氟离子, 成骨细胞, 黏着斑

Abstract:

Objective To evaluate the chemical composition of the modified surface of fluoride ion - implanted titanium and assess the effect on the formation of focal adhesion plaque in vitro. Methods Pure commercial titanium discs were treated with fluoride ion implantation by plasma immersion ion implantation technique(PIII) and chemical composition and value of the surface modification layer were characterized by X- ray photoelectron spectrometer(XPS). In order to investigate the formation of focal adhesion plaque, MG- 63 cells were seeded onto the surfaces of the modified Ti discs and quantified by morphometric analysis using an immunofluorescence microscope. Results The full range XPS spectra and fitting results indicated that the surface of fluoride ion- implanted titanium was the mixture of titanium dioxide and titanium trifluoride. Meanwhile, the quantity of focal adhesion plaque on fluoride ion- implanted titanium was more than that on the non- implanted titanium after 6 hours′cell culture. Conclusion The XPS data revealed that the modified surface layer of fluoride ion- implanted titanium contained titanium dioxide and titanium trifluoride, which could enhance the formation of focal adhesion plaque.

Key words: titanium, plasma immersion ion implantation technique, fluoride ion, osteoblast, focal adhesion plaque